Generac iQ5200
3900 W, dual-fuel
Pulsar PGD40iSCO
Generator. Specs from the manufacturer page (checked ).
The Pulsar PGD40iSCO is a gasoline inverter generator rated at 4,000 peak watts and 3,200 running watts, with a 145cc recoil-start engine and a 1-gallon fuel tank. It weighs 47 pounds and is rated at 59 dB.
Check on Amazon →Sponsored link; we may earn a commission.
Running
3200W
Peak / surge
4000W
Fuel
gasoline
Run time @50 %
4.5h
Noise
59dB
CO shutoff
Yes
Weight
21.32kg
Key features
- Two standard 120V 20-amp outlets and one 120V 30-amp RV outlet
- Provides 4,000 peak watts and 3,200 rated watts
- Runs up to 4.5 hours at half load on a 1-gallon fuel tank
- 145cc OHV air-cooled recoil-start engine running on standard gasoline
- Rated at 59 dB
- Stable sine wave output for sensitive electronics such as cell phones and laptops
- Automatically shuts down when excess carbon monoxide is detected (CO alert/shutdown)
- Parallel capable: link two units to double output
What it is for
- emergency backup power
- camping
- tailgating
- RV parks
Specifications
| Running watts | 3200 W |
|---|---|
| Peak / surge | 4000 W |
| Fuel | gasoline |
| Tank | 3.785 L (1.0 gal) |
| Run time at 50 % load | 4.5 h |
| Noise | 59 dB |
| CO shutoff | Yes |
| AC output voltage | 120V |
| Weight | 21.32 kg (47.0 lb) |
From the Pulsar page. Values the manufacturer does not publish are left out.
Similar inverter & portable generators
WEN DF480iX
4000 W, dual-fuel
WEN DF475T
3800 W, dual-fuel
Anker SOLIX Smart Generator 5500
3600 W, tri-fuel
Honda EU3200i
2600 W, gas
A-iPower AP3700i
3200 W, gasoline
EcoFlow Smart Generator (Dual Fuel)
3200 W, dual-fuel
GenMax GM3500iAED
3200 W, dual-fuel
Pulsar PGD40iSCO comparisons
- PGD40iSCO vs Generac iQ5200
- PGD40iSCO vs WEN DF480iX
- PGD40iSCO vs WEN DF475T
- PGD40iSCO vs Anker SOLIX Smart Generator 5500
- PGD40iSCO vs Honda EU3200i
Connection and wiring
Follow the diagrams in the Pulsar manual. Connecting to a home panel needs a transfer switch or interlock and a licensed electrician.
Open the Pulsar manual (PDF) →
Error codes and troubleshooting
We found no error-code table in this manual. Its troubleshooting section is the reference.
FAQ
How long does the Pulsar PGD40iSCO run on a tank?
The maker rates it at 4.5 hours at 50 % load (about 1,600 W) on a 1.0-gal tank. A light load such as a refrigerator and lights runs longer; a full load runs shorter.
Can the Pulsar PGD40iSCO start a sump pump or well pump?
Starting surge matters more than running watts: this unit is rated 4000 W peak. That covers a typical 1/2 HP sump pump (about 2150 W to start). Use the calculator with your exact pump.