WEN PP300i Overload
What it means: Too much power is being drawn from the power station. It cuts off power to protect itself and the battery, and the overload alarm icon appears on the display.
What to do
Disconnect the load and press the appropriate power button on the panel to reset the circuit.
When to call service
The manual lists steps the owner can take. If the code comes back after them, or you are unsure, contact an authorized service dealer. The unit stops or will not start until the cause is cleared.
Source: official WEN manual, page 11, read . Summary of the manual, not a reproduction.
Models this manual covers
Overload in other WEN manuals
- DF875iX: Generator was overloaded by too much drawn wattage. The overload reset button activates and cuts output within 3 to 16 seconds, depending on load.
- PP448i: If too much power is drawn, the station cuts off power to protect itself and the battery. Motor-driven devices can need up to 3 times their running power at startup and may be difficult or impossible to use.
Other PP300i codes
Questions
What does WEN Overload mean?
Too much power is being drawn from the power station. It cuts off power to protect itself and the battery, and the overload alarm icon appears on the display. (WEN manual for the PP300i, page 11.)
How do I fix WEN Overload?
Disconnect the load and press the appropriate power button on the panel to reset the circuit.
Fuel, gas and electrical work on a power station is for qualified technicians; follow the safety section of the manual. All 9 PP300i codes →