WEN DF875iX Overload
What it means: Generator was overloaded by too much drawn wattage. The overload reset button activates and cuts output within 3 to 16 seconds, depending on load.
What to do
Turn off and disconnect electrical devices until the overload light turns off. Wait about five minutes, then press the activated reset button. If no power after reset, turn off and disconnect all devices and restart the generator.
When to call service
The manual lists steps the owner can take. If the code comes back after them, or you are unsure, contact an authorized service dealer. The unit stops or will not start until the cause is cleared.
Source: official WEN manual, page 23, read . Summary of the manual, not a reproduction.
Models this manual covers
WEN DF875iX, WEN DF402iX, WEN GN875iX, WEN GN625iX, WEN GN400iX, WEN GN625i.
Overload in other WEN manuals
- PP300i: Too much power is being drawn from the power station. It cuts off power to protect itself and the battery, and the overload alarm icon appears on the display.
- PP448i: If too much power is drawn, the station cuts off power to protect itself and the battery. Motor-driven devices can need up to 3 times their running power at startup and may be difficult or impossible to use.
Other DF875iX codes
Questions
What does WEN Overload mean?
Generator was overloaded by too much drawn wattage. The overload reset button activates and cuts output within 3 to 16 seconds, depending on load. (WEN manual for the DF875iX, page 23.)
How do I fix WEN Overload?
Turn off and disconnect electrical devices until the overload light turns off. Wait about five minutes, then press the activated reset button. If no power after reset, turn off and disconnect all devices and restart the generator.
Fuel, gas and electrical work on a portable / inverter generator is for qualified technicians; follow the safety section of the manual. All 7 DF875iX codes →