Bluetti AC180T
Power station · SwapSolar. Specs from the manufacturer page (checked ).

The Bluetti AC180T is a 1,433 Wh portable power station with 1,800 W AC output and a 2,700 W Power Lifting mode for resistive loads such as electric heaters and hairdryers. It uses two swappable B70 batteries of 716 Wh each, with LiFePO4 cells rated for over 3,000 charge cycles to 80%.
Key features
- 1,800 W AC output; Power Lifting mode supports resistive loads up to 2,700 W
- Two swappable B70 batteries (716 Wh each), 1,433 Wh total capacity
- Output limited to 1,200 W when only one battery is inserted
- 0-80% recharge in 45 minutes with 1,440 W AC input
- Full charge in 1.1 hours from a wall outlet, 3 hours from solar, 8 hours from a vehicle
- 9 output ports for multiple devices
- Bluetooth control and monitoring through the BLUETTI app
- BLUETOPUS battery management system protects against overcharging, discharging and overheating
What it is for
- multi-day power outage
- road trips
- off-grid lifestyle
Specifications
| Capacity | 1433 Wh |
|---|---|
| Continuous output | 1800 W |
| Peak / surge | 2700 W |
| Battery chemistry | LiFePO4 |
| Cycle life | 3000 cycles |
| AC charging | Plug into the wall for a full charge in just 1.1 hours |
| Warranty | 5 years |
From the Bluetti page. Values the manufacturer does not publish are left out.
How long it runs common appliances
| Appliance | Watts | Runs? | Hours |
|---|---|---|---|
| Refrigerator (with freezer) | 120 W (600 start) | yes | 27 h |
| Chest freezer | 100 W (500 start) | yes | 38 h |
| CPAP (no humidifier) | 35 W (40 start) | yes | 32 h |
| Gas boiler (pump + controls) | 120 W (300 start) | yes | 19 h |
| Wi-Fi router + modem/ONU | 12 W | yes | 3.9 days |
| Starlink (standard dish) | 60 W (100 start) | yes | 19 h |
| TV 50" | 75 W | yes | 15 h |
| Sump pump 1/2 HP | 920 W (2150 start) | yes | 1.2 h |
| Well pump 1/2 HP | 880 W (2000 start) | yes | 1.3 h |
| Space heater 1500 W | 1500 W | yes | 1.1 h |
Assumes 88 % inverter efficiency, 90 % usable capacity and typical duty cycles. Build your own list in the calculator.
Similar portable power stations
Vtoman FlashSpeed 2400
Vtoman Jump 1800
Dabbsson DBS1400 Pro
Enphase IQ PowerPack 1500
Anker SOLIX F1500
Jackery Explorer 1500 Ultra
Jackery Explorer 1500 v2
On our lists
Connection and wiring
Follow the diagrams in the Bluetti manual.
Open the Bluetti manual (PDF) →
Error codes and troubleshooting
| Code | Meaning | What to do | Manual page |
|---|---|---|---|
| E004 | The output voltage is outside the expected range, or the grid connection is not proper. | Ensure the output voltage is within ±10% of the rated voltage or proper grid connection. | 21 |
| E016 | The internal fan is blocked, unplugged, or not functioning properly. | Check if the fan is blocked, unplugged, or not functioning properly. Ensure proper ventilation. | 21 |
| E117 | Grid oscillation has been detected at the grid input. | Disconnect the grid input and contact BLUETTI support for further assistance. Call service if it persists. | 21 |
| E074 | The battery management system (BMS) has detected a fault. The specific fault is shown in the mobile app. | Check the specific fault in the mobile app. If the battery is too hot or too cold, let the unit reach a suitable temperature before charging or using it (charging -15°C to 40°C; discharging -25°C to 40°C). | 22 |
| Others | Other errors not listed in the error code table. | Contact BLUETTI support for help. Call service if it persists. | 22 |
| E001 | The inverter is overloaded because the connected devices draw too much power. | Check whether the power consumption of your devices is too high. Reduce the load if necessary. | 23 |
6 of 23 codes. From the Bluetti manual. All 23 Elite 200 V2 / Apex 300 / Elite 100 V2 / AC70 codes →
FAQ
How long will the Bluetti AC180T run a refrigerator?
About 27 hours for a typical 120 W refrigerator that runs 35 % of the time, after inverter and depth-of-discharge losses.
Can the Bluetti AC180T start a sump pump or well pump?
Starting surge matters more than running watts: this unit is rated 2700 W peak. That covers a typical 1/2 HP sump pump (about 2150 W to start). Use the calculator with your exact pump.