Blackout Sizer Calculator
EN
Home›Portable Power Stations›Bluetti›AC50P

Bluetti AC50P

Power station. Specs from the manufacturer page (checked ).

Bluetti AC50P
Photo: Bluetti

The BLUETTI AC50P is a 504 Wh portable power station with 700 W rated output and LiFePO4 battery cells. Its Power Lifting Mode drives pure resistive loads up to 1,200 W, and the B80 expansion battery (sold separately) adds 806 Wh.

Check on Amazon →Sponsored link; we may earn a commission.
Capacity
504Wh
Continuous
700W
Chemistry
LiFePO4
Expandable
Yes
Warranty
5yr

Key features

What it is for

Specifications

Capacity504 Wh
Continuous output700 W
ExpandableYes
Battery chemistryLiFePO4
Noise45 dB
Warranty5 years

From the Bluetti page. Values the manufacturer does not publish are left out.

What is in the box

How long it runs common appliances

ApplianceWattsRuns?Hours
Refrigerator (with freezer)120 W (600 start)yes9.5 h
Chest freezer100 W (500 start)yes13 h
CPAP (no humidifier)35 W (40 start)yes11 h
Gas boiler (pump + controls)120 W (300 start)yes6.7 h
Wi-Fi router + modem/ONU12 Wyes33 h
Starlink (standard dish)60 W (100 start)yes6.7 h
TV 50"75 Wyes5.3 h
Sump pump 1/2 HP920 W (2150 start)surge too high—
Well pump 1/2 HP880 W (2000 start)surge too high—
Space heater 1500 W1500 Wsurge too high—

Assumes 88 % inverter efficiency, 90 % usable capacity and typical duty cycles. Build your own list in the calculator.

Similar portable power stations

Bluetti AC50P comparisons

All Bluetti models →

Connection and wiring

Follow the diagrams in the Bluetti manual.

Open the Bluetti manual (PDF) →

Error codes and troubleshooting

CodeMeaningWhat to doManual page
E004The output voltage is outside the expected range, or the grid connection is not proper.Ensure the output voltage is within ±10% of the rated voltage or proper grid connection.21
E016The internal fan is blocked, unplugged, or not functioning properly.Check if the fan is blocked, unplugged, or not functioning properly. Ensure proper ventilation.21
E117Grid oscillation has been detected at the grid input.Disconnect the grid input and contact BLUETTI support for further assistance. Call service if it persists.21
E074The battery management system (BMS) has detected a fault. The specific fault is shown in the mobile app.Check the specific fault in the mobile app. If the battery is too hot or too cold, let the unit reach a suitable temperature before charging or using it (charging -15°C to 40°C; discharging -25°C to 40°C).22
E001The inverter is overloaded because the connected devices draw too much power.Check whether the power consumption of your devices is too high. Reduce the load if necessary.23
E002The inverter overheated and protection switched the AC output off.Wait for about 10 minutes until the unit cools down, then turn on the AC output again.23

6 of 22 codes. From the Bluetti manual. All 22 Elite 200 V2 / Apex 300 / Elite 100 V2 / AC70 codes →

FAQ

How long will the Bluetti AC50P run a refrigerator?

About 10 hours for a typical 120 W refrigerator that runs 35 % of the time, after inverter and depth-of-discharge losses.

Can the Bluetti AC50P start a sump pump or well pump?

Starting surge matters more than running watts: this unit is rated 700 W output (no separate peak published). That is below a typical 1/2 HP sump pump start (about 2150 W); check your pump label. Use the calculator with your exact pump.

Bluetti AC50PCheck on Amazon