Pulsar GD400BN
3200 W, dual-fuel
Honda EB2800i
Generator · EB. Specs from the manufacturer page (checked ).
The Honda EB2800i is a gasoline-fueled inverter generator rated at 2500 W output with a 2800 W surge. Its owner's manual requires outdoor use only, at least 3 feet (1 meter) from buildings, and it must never run in a closed or partly closed area.
Check on Amazon →Sponsored link; we may earn a commission.
Running
2500W
Peak / surge
2800W
Fuel
gasoline
Weight
30.3kg
Warranty
3yr
Key features
- Runs on gasoline: unleaded, pump octane 86 or higher, up to 10% ethanol (E10) or 5% methanol by volume
- Shipped without engine oil; add about 15 to 16 ounces of SAE 10W-30 API SJ or later oil
- Do not fill the fuel tank above the red upper level mark on the fuel strainer
- Move at least 10 feet (3 meters) from the fueling source before starting the engine
- Includes a GFCI operation check and an Eco Throttle System
- Keep at least 3 feet (1 meter) from buildings and other equipment during operation
What it is for
- standby power
Specifications
| Running watts | 2500 W |
|---|---|
| Peak / surge | 2800 W |
| Fuel | gasoline |
| Tank | 8.1 L (2.1 gal) |
| Weight | 30.3 kg (66.8 lb) |
| Dimensions | 43 × 44.8 × 48.1 cm (16.9 × 17.6 × 18.9 in) |
| Warranty | 3 years |
From the Honda page. Values the manufacturer does not publish are left out.
Similar inverter & portable generators
Generac 2500i
2200 W
Westinghouse iGen2800DFc
2200 W, dual-fuel
Firman W03383
3300 W, gasoline
WEN 56360iX
2900 W
Generac GP3000i
2300 W
Ryobi RYI2322E
2300 W
WEN DF280iX
2250 W, dual-fuel
Honda EB2800i comparisons
- EB2800i vs Pulsar GD400BN
- EB2800i vs Generac 2500i
- EB2800i vs Westinghouse iGen2800DFc
- EB2800i vs Firman W03383
- EB2800i vs WEN 56360iX
Connection and wiring
Follow the diagrams in the Honda manual. Connecting to a home panel needs a transfer switch or interlock and a licensed electrician.
Error codes and troubleshooting
| Code | Meaning | What to do | Manual page |
|---|---|---|---|
| AC CIRCUIT PROTECTOR | Switches to OFF automatically when there is a short circuit or a significant overload at the 20A receptacles. | Check that the appliance works properly and does not exceed the circuit's rated load capacity before pushing the protector to reset it ON. | 6 |
| CO ALARM | CO-MINDER detected a high carbon monoxide concentration and stopped the engine. The indicator flashes for about five minutes. | Move the generator to fresh air, away from the source of carbon monoxide, and not in an enclosed area. Press the CO-MINDER reset button, then restart using the standard procedure. If the indicator stays on after reset, the sensor may be near end of life. | 7 |
| FAULT/CO SENSOR LIFE | The CO-MINDER sensor is reaching the end of its useful life. Flashing once every 4 seconds means about 6 months to 1 year remains. Flashing once every 2 seconds means about 6 months or less remains. | Contact an authorized Honda Power Equipment dealer for CO sensor replacement. Call service if it persists. | 7 |
| Oil Alert Indicator/Check | Crankcase oil level has fallen below a safe limit. The Oil Alert system automatically stops the engine to prevent damage, while the engine switch stays in the ON position. | Check the engine oil level before troubleshooting other areas. Add oil as needed. | 7 |
| Overload Alarm | Generator is overloaded (over 2.8 kVA), a connected appliance has a short circuit, or the inverter is overheated. Output shuts off after about 4-10 seconds while the engine keeps running. A brief alarm when a motor starts is normal. | Stop the engine and investigate. Determine whether the cause is a short circuit in an appliance or an overload, correct it, then restart. If the alarm stays on during motor startup, consult your generator dealer. | 7 |
| End of serviceable life | The GFCI LED is on, indicating the GFCI has reached the end of its serviceable life. | This section gives no specific repair step for this state. If the GFCI does not function as described in the operation check, contact an authorized Honda generator dealer. Call service if it persists. | 9 |
6 of 15 codes. From the Honda manual. All 15 EU2200i / EU7000iS / EG4000 / EU3000iS codes →
FAQ
Can the Honda EB2800i start a sump pump or well pump?
Starting surge matters more than running watts: this unit is rated 2800 W peak. That covers a typical 1/2 HP sump pump (about 2150 W to start). Use the calculator with your exact pump.