Pulsar PG15KVTWBCO
Generator · Pulsar. Specs from the manufacturer page (checked ).

The Pulsar PG15KVTWBCO is a dual-fuel portable generator rated at 12,000 running watts and 15,000 peak watts on gasoline. It runs on gasoline or propane, with a 713cc V-Twin engine and 120V and 240V output. On gasoline, its 10.6-gallon tank gives up to 9 hours of continuous operation at half load.
Key features
- Rated 15,000 W peak and 12,000 W running on gasoline; 13,500 W peak and 11,000 W running on propane
- Dual fuel: 713cc V-Twin engine runs on gasoline or propane
- 10.6-gallon fuel tank gives up to 9 hours of continuous operation at half load on gasoline
- Electric push-button start
- Four 120V GFCI AC outlets, one 120/240V 50A RV outlet, one 120/240V L14-30R twist-lock outlet, and one 120/240V L5-30R twist-lock outlet
- Low oil shutdown, automatic voltage regulation, and carbon monoxide detection
- Digital meter displays voltage, frequency, run time, total hours, and maintenance
- Fold-down handles and 12-inch never-flat wheels
What it is for
- home backup during power outages
- job sites
- outdoor events
- off-grid living
Specifications
| Running watts | 12000 W |
|---|---|
| Peak / surge | 15000 W |
| Fuel | dual-fuel |
| Tank | 40.1 L (10.6 gal) |
| Run time at 50 % load | 9 h |
| CO shutoff | Yes |
| AC output voltage | 120V/240V |
From the Pulsar page. Values the manufacturer does not publish are left out.
What is in the box
- Starter battery
- Propane hose
Similar inverter & portable generators
DuroMax XP15000HXT
DuroMax XP15000EH
DuroMax XP16000iH
DuroMax XP16000iHT
DuroMax XP13000EH
DuroMax XP13000HX
DuroMax XP13000HXT
Connection and wiring
Follow the diagrams in the Pulsar manual. Connecting to a home panel needs a transfer switch or interlock and a licensed electrician.
Error codes and troubleshooting
| Code | Meaning | What to do | Manual page |
|---|---|---|---|
| RED | Carbon monoxide has accumulated around the generator and the unit shut off due to a CO hazard. The red light flashes for at least five minutes after shut-off. Automatic shutoff with a flashing red light means the generator was improperly located. | Move the generator to an open outdoor area far from occupied spaces, with the exhaust pointed away. Once it is in a safe area, it can be restarted. Introduce fresh air and ventilate the area where the generator shut down. | 4 |
| YELLOW | A CO Sentry system fault occurred. The generator shut down automatically, and the yellow light flashes for at least five minutes after the fault. | The generator can be restarted, but it may continue to shut off. | 4 |
| CO | Detects the presence of carbon monoxide and may shut down the unit automatically for safety. | The manual gives no specific reset step for this indicator. If dizziness, weakness, or nausea occur, turn the unit off, move to fresh air, and seek medical attention. Operate only outdoors, away from enclosed spaces. | 5 |
| Low Oil LED | The engine oil level has fallen below the safe operating limit (270 ml or less). The engine shuts off automatically and cannot restart until the proper oil amount is added. | Add the appropriate oil until the level is at the proper mark. SAE 10W-30 is recommended for general use. Do not run the engine with too little oil. | 14 |
| OVERLOAD | The total load on the outlets exceeds the generator's running power. If the light turns on and the generator stops producing power, it has been overloaded. The light may flash briefly when a large device starts. | Turn off and disconnect all electrical devices and stop the engine. Compare device requirements to the generator rating and reduce connected wattage if necessary. Check and reset any tripped circuit breakers, then restart and reconnect devices without overloading. | 14 |
| LOW OIL | The engine oil level is too low. The engine shuts off automatically when the oil falls below a critical level. | Add the appropriate oil, SAE 10w-30 recommended for general use, until the oil is at the proper level. The engine cannot be restarted until the proper amount of oil has been added. | 15 |
6 of 8 codes. From the Pulsar manual. All 8 PG12000BCO / PG7750BCO / PG6580BCO / PG105TiSRCO codes →
FAQ
How long does the Pulsar PG15KVTWBCO run on a tank?
The maker rates it at 9 hours at 50 % load (about 6,000 W) on a 10.6-gal tank. A light load such as a refrigerator and lights runs longer; a full load runs shorter.
Can the Pulsar PG15KVTWBCO start a sump pump or well pump?
Starting surge matters more than running watts: this unit is rated 15000 W peak. That covers a typical 1/2 HP sump pump (about 2150 W to start). Use the calculator with your exact pump.