Honda EU3000iS
3000 W
Pulsar PG3500MRCO
Generator. Specs from the manufacturer page (checked ).
The Pulsar PG3500MRCO is a portable gas generator rated at 3,000 running watts and 3,500 peak watts, powered by a 212cc OHV 6HP gasoline engine. It has a four-gallon fuel tank that provides up to 14 hours of run time at half load. It includes two 120V outlets and one 12V DC output for battery charging.
View at Pulsar →Sponsored link; we may earn a commission.
Running
3000W
Peak / surge
3500W
Fuel
gasoline
Run time @50 %
14h
CO shutoff
Yes
Key features
- 3,500 peak watts and 3,000 running watts
- 212cc OHV 6HP gasoline engine with recoil start
- Sentry CO sensor automatically turns off the generator when excess carbon monoxide is detected
- Low oil indicator with automatic low oil shutdown
- Four-gallon fuel tank provides 14 hours of run time at half load
- Two 120V outlets and one 12V DC output for battery charging
- Mobility kit with fold-down handle and never-flat wheels
- CARB and EPA approved
What it is for
- Emergency backup power
- Camping and outdoor events
- Construction and job sites
- Outdoor recreation
Specifications
| Running watts | 3000 W |
|---|---|
| Peak / surge | 3500 W |
| Fuel | gasoline |
| Tank | 15.14 L (4.0 gal) |
| Run time at 50 % load | 14 h |
| CO shutoff | Yes |
| AC output voltage | 120V |
From the Pulsar page. Values the manufacturer does not publish are left out.
Similar inverter & portable generators
Firman WH02942
2900 W, dual-fuel
WEN 56360i
2900 W
WEN 56360iX
2900 W
WEN DF360iX
2900 W, dual-fuel
A-iPower AP3700i
3200 W, gasoline
EcoFlow Smart Generator (Dual Fuel)
3200 W, dual-fuel
PowerSmart 4000W Inverter Generator
3200 W
Connection and wiring
Follow the diagrams in the Pulsar manual. Connecting to a home panel needs a transfer switch or interlock and a licensed electrician.
Open the Pulsar manual (PDF) →
Error codes and troubleshooting
| Code | Meaning | What to do | Manual page |
|---|---|---|---|
| RED | Carbon monoxide has accumulated around the generator and the unit shut off due to a CO hazard. The red light flashes for at least five minutes after shut-off. Automatic shutoff with a flashing red light means the generator was improperly located. | Move the generator to an open outdoor area far from occupied spaces, with the exhaust pointed away. Once it is in a safe area, it can be restarted. Introduce fresh air and ventilate the area where the generator shut down. | 4 |
| YELLOW | A CO Sentry system fault occurred. The generator shut down automatically, and the yellow light flashes for at least five minutes after the fault. | The generator can be restarted, but it may continue to shut off. | 4 |
| CO | Detects the presence of carbon monoxide and may shut down the unit automatically for safety. | The manual gives no specific reset step for this indicator. If dizziness, weakness, or nausea occur, turn the unit off, move to fresh air, and seek medical attention. Operate only outdoors, away from enclosed spaces. | 5 |
| Low Oil LED | The engine oil level has fallen below the safe operating limit (270 ml or less). The engine shuts off automatically and cannot restart until the proper oil amount is added. | Add the appropriate oil until the level is at the proper mark. SAE 10W-30 is recommended for general use. Do not run the engine with too little oil. | 14 |
| OVERLOAD | The total load on the outlets exceeds the generator's running power. If the light turns on and the generator stops producing power, it has been overloaded. The light may flash briefly when a large device starts. | Turn off and disconnect all electrical devices and stop the engine. Compare device requirements to the generator rating and reduce connected wattage if necessary. Check and reset any tripped circuit breakers, then restart and reconnect devices without overloading. | 14 |
| LOW OIL | The engine oil level is too low. The engine shuts off automatically when the oil falls below a critical level. | Add the appropriate oil, SAE 10w-30 recommended for general use, until the oil is at the proper level. The engine cannot be restarted until the proper amount of oil has been added. | 15 |
6 of 8 codes. From the Pulsar manual. All 8 PG12000BCO / PG7750BCO / PG6580BCO / PG105TiSRCO codes →
FAQ
How long does the Pulsar PG3500MRCO run on a tank?
The maker rates it at 14 hours at 50 % load (about 1,500 W) on a 4.0-gal tank. A light load such as a refrigerator and lights runs longer; a full load runs shorter.
Can the Pulsar PG3500MRCO start a sump pump or well pump?
Starting surge matters more than running watts: this unit is rated 3500 W peak. That covers a typical 1/2 HP sump pump (about 2150 W to start). Use the calculator with your exact pump.