WEN GN5602X
4500 W, gasoline
Pulsar PG5000BiSRCO
Generator. Specs from the manufacturer page (checked ).
The Pulsar PG5000BiSRCO is a dual-fuel inverter generator rated at 4000 W running and 5000 W peak on gasoline. On propane it is rated at 3600 W running and 4500 W peak, and its 3-gallon fuel tank provides up to 9 hours of continuous operation at half load. It includes CO Sentry carbon monoxide detection and overload protection.
Check on Amazon →Sponsored link; we may earn a commission.
Running
4000W
Peak / surge
5000W
Fuel
dual-fuel
Run time @50 %
9h
Key features
- Dual fuel: gasoline rated 4000 W running and 5000 W peak; propane rated 3600 W running and 4500 W peak
- Covered outlets: one 120V 30A RV (TT-30R), two 120V 20A household (5-20R), and two USB outlets (USB-A and USB-C)
- 3-gallon fuel tank provides up to 9 hours of continuous operation at half load
- Multiple start methods: remote start, electric start, and recoil start
- Parallel capable, allowing two generators to be linked to increase power output
- Overload protection and CO Sentry carbon monoxide detection
- Economy mode reduces fuel consumption
- Telescoping handle with wheel kit; quiet operation rated at 65 dB
What it is for
- RV or recreational use
- emergency power
- work
- outdoor recreation
Specifications
| Running watts | 4000 W |
|---|---|
| Peak / surge | 5000 W |
| Fuel | dual-fuel |
| Tank | 11.355 L (3.0 gal) |
| Run time at 50 % load | 9 h |
| AC output voltage | 120V |
From the Pulsar page. Values the manufacturer does not publish are left out.
What is in the box
- Propane hose
- Remote control fob
Similar inverter & portable generators
WEN DF480iX
4000 W, dual-fuel
WEN DF475T
3800 W, dual-fuel
Anker SOLIX Smart Generator 5500
3600 W, tri-fuel
Champion 5500-Watt Dual Fuel Inverter
4000 W, dual-fuel
A-iPower GXS5000RD
4000 W, dual-fuel
Firman T04073
4000 W, tri-fuel
WEN 56477i
4000 W, gasoline
Pulsar PG5000BiSRCO comparisons
- PG5000BiSRCO vs WEN GN5602X
- PG5000BiSRCO vs WEN DF480iX
- PG5000BiSRCO vs WEN DF475T
- PG5000BiSRCO vs Anker SOLIX Smart Generator 5500
- PG5000BiSRCO vs Champion 5500-Watt Dual Fuel Inverter
Connection and wiring
Follow the diagrams in the Pulsar manual. Connecting to a home panel needs a transfer switch or interlock and a licensed electrician.
Error codes and troubleshooting
| Code | Meaning | What to do | Manual page |
|---|---|---|---|
| RED | Carbon monoxide has accumulated around the generator and the unit shut off due to a CO hazard. The red light flashes for at least five minutes after shut-off. Automatic shutoff with a flashing red light means the generator was improperly located. | Move the generator to an open outdoor area far from occupied spaces, with the exhaust pointed away. Once it is in a safe area, it can be restarted. Introduce fresh air and ventilate the area where the generator shut down. | 4 |
| YELLOW | A CO Sentry system fault occurred. The generator shut down automatically, and the yellow light flashes for at least five minutes after the fault. | The generator can be restarted, but it may continue to shut off. | 4 |
| CO | Detects the presence of carbon monoxide and may shut down the unit automatically for safety. | The manual gives no specific reset step for this indicator. If dizziness, weakness, or nausea occur, turn the unit off, move to fresh air, and seek medical attention. Operate only outdoors, away from enclosed spaces. | 5 |
| Low Oil LED | The engine oil level has fallen below the safe operating limit (270 ml or less). The engine shuts off automatically and cannot restart until the proper oil amount is added. | Add the appropriate oil until the level is at the proper mark. SAE 10W-30 is recommended for general use. Do not run the engine with too little oil. | 14 |
| OVERLOAD | The total load on the outlets exceeds the generator's running power. If the light turns on and the generator stops producing power, it has been overloaded. The light may flash briefly when a large device starts. | Turn off and disconnect all electrical devices and stop the engine. Compare device requirements to the generator rating and reduce connected wattage if necessary. Check and reset any tripped circuit breakers, then restart and reconnect devices without overloading. | 14 |
| LOW OIL | The engine oil level is too low. The engine shuts off automatically when the oil falls below a critical level. | Add the appropriate oil, SAE 10w-30 recommended for general use, until the oil is at the proper level. The engine cannot be restarted until the proper amount of oil has been added. | 15 |
6 of 8 codes. From the Pulsar manual. All 8 PG12000BCO / PG7750BCO / PG6580BCO / PG105TiSRCO codes →
FAQ
How long does the Pulsar PG5000BiSRCO run on a tank?
The maker rates it at 9 hours at 50 % load (about 2,000 W) on a 3.0-gal tank. A light load such as a refrigerator and lights runs longer; a full load runs shorter.
Can the Pulsar PG5000BiSRCO start a sump pump or well pump?
Starting surge matters more than running watts: this unit is rated 5000 W peak. That covers a typical 1/2 HP sump pump (about 2150 W to start). Use the calculator with your exact pump.