A-iPower GXS7600iRD
6100 W, dual-fuel
Pulsar PG7750BCO
Generator · Pulsar Dual Fuel Portable Generator. Specs from the manufacturer page (checked ).
The Pulsar PG7750BCO is a dual-fuel portable generator rated at 6,250 W running and 7,750 W peak on gasoline. It also runs on LPG, rated at 6,000 W running and 7,500 W peak, and includes a propane hose for LPG operation.
View at Pulsar →Sponsored link; we may earn a commission.
Running
6250W
Peak / surge
7750W
Fuel
dual-fuel
Run time @50 %
9.5h
CO shutoff
Yes
Key features
- Gasoline output: 7,750 W peak and 6,250 W rated; LPG output: 7,500 W peak and 6,000 W rated
- 6.6 gal fuel tank gives up to 9.5 hours of continuous operation at half load on gasoline
- Electric and recoil start
- Four 120-volt AC outlets, plus two 120/240v twist-lock outlets (L5-30R and L14-30R)
- Switch & Go technology switches fuel sources while the generator is running
- Digital meter shows voltage, frequency, run time, total hours, and maintenance
- Low oil indication and low oil shutdown
- Carbon monoxide detection; 420 cc, 4-stroke, OHV, air-cooled engine
What it is for
- Home backup during power outages
- Job site power for equipment
- Camping and tailgating
Specifications
| Running watts | 6250 W |
|---|---|
| Peak / surge | 7750 W |
| Fuel | dual-fuel |
| Tank | 25 L (6.6 gal) |
| Run time at 50 % load | 9.5 h |
| CO shutoff | Yes |
| AC output voltage | 120/240v |
From the Pulsar page. Values the manufacturer does not publish are left out.
What is in the box
- Propane hose
Similar inverter & portable generators
A-iPower SUA7600iED
6100 W, dual-fuel
WEN DF8000X
6500 W, dual-fuel
Yamaha EF7200DE/D
6000 W
Briggs & Stratton 5750 Watt Portable Generator
5750 W, gasoline
Firman H05752
5700 W, dual-fuel
Briggs & Stratton 7000 Watt Elite Series
7000 W, gasoline
Champion 5500-Watt Dual Fuel
5500 W, dual-fuel
Connection and wiring
Follow the diagrams in the Pulsar manual. Connecting to a home panel needs a transfer switch or interlock and a licensed electrician.
Open the Pulsar manual (PDF) →
Error codes and troubleshooting
| Code | Meaning | What to do | Manual page |
|---|---|---|---|
| RED | Carbon monoxide has accumulated around the generator and the unit shut off due to a CO hazard. The red light flashes for at least five minutes after shut-off. Automatic shutoff with a flashing red light means the generator was improperly located. | Move the generator to an open outdoor area far from occupied spaces, with the exhaust pointed away. Once it is in a safe area, it can be restarted. Introduce fresh air and ventilate the area where the generator shut down. | 4 |
| YELLOW | A CO Sentry system fault occurred. The generator shut down automatically, and the yellow light flashes for at least five minutes after the fault. | The generator can be restarted, but it may continue to shut off. | 4 |
| CO | Detects the presence of carbon monoxide and may shut down the unit automatically for safety. | The manual gives no specific reset step for this indicator. If dizziness, weakness, or nausea occur, turn the unit off, move to fresh air, and seek medical attention. Operate only outdoors, away from enclosed spaces. | 5 |
| Low Oil LED | The engine oil level has fallen below the safe operating limit (270 ml or less). The engine shuts off automatically and cannot restart until the proper oil amount is added. | Add the appropriate oil until the level is at the proper mark. SAE 10W-30 is recommended for general use. Do not run the engine with too little oil. | 14 |
| OVERLOAD | The total load on the outlets exceeds the generator's running power. If the light turns on and the generator stops producing power, it has been overloaded. The light may flash briefly when a large device starts. | Turn off and disconnect all electrical devices and stop the engine. Compare device requirements to the generator rating and reduce connected wattage if necessary. Check and reset any tripped circuit breakers, then restart and reconnect devices without overloading. | 14 |
| LOW OIL | The engine oil level is too low. The engine shuts off automatically when the oil falls below a critical level. | Add the appropriate oil, SAE 10w-30 recommended for general use, until the oil is at the proper level. The engine cannot be restarted until the proper amount of oil has been added. | 15 |
6 of 8 codes. From the Pulsar manual. All 8 PG12000BCO / PG7750BCO / PG6580BCO / PG105TiSRCO codes →
FAQ
How long does the Pulsar PG7750BCO run on a tank?
The maker rates it at 9.5 hours at 50 % load (about 3,125 W) on a 6.6-gal tank. A light load such as a refrigerator and lights runs longer; a full load runs shorter.
Can the Pulsar PG7750BCO start a sump pump or well pump?
Starting surge matters more than running watts: this unit is rated 7750 W peak. That covers a typical 1/2 HP sump pump (about 2150 W to start). Use the calculator with your exact pump.