Westinghouse WGen9500DFc
9500 W, dual-fuel
Pulsar PGD95BISCO
Generator · Pulsar Dual-Fuel Inverter Generator. Specs from the manufacturer page (checked ).
The Pulsar PGD95BISCO is a dual-fuel inverter generator rated at 9,500 peak watts and 7,600 running watts on gasoline. On propane it is rated at 8,550 peak watts and 7,200 running watts. It is described for residential backup power and mobile applications.
Check on Amazon →Sponsored link; we may earn a commission.
Running
7600W
Peak / surge
9500W
Fuel
dual-fuel
Run time @50 %
9.5h
CO shutoff
Yes
Key features
- Runs on gasoline (9,500 peak W, 7,600 running W) or propane (8,550 peak W, 7,200 running W)
- Outlets: 1 USB-A, 1 USB-C, 4 GFCI 120V 5-20R, 1 120V/240V L14-30R, 1 120V/240V L14-50R
- Remote, electric, and recoil start; battery included; can be started or stopped from up to 80 feet away
- Parallel capability to combine two generators and double output
- Digital control center shows hours, voltage, load, and frequency
- 458cc OHV 4-cycle engine in an enclosed frame, rated 62 dBA
- Up to 9.5 hours at half load on a single tank of gasoline
- Safety: overload protection, circuit breakers, low oil shutdown, and automatic shutdown on high carbon monoxide
What it is for
- residential backup power
- mobile applications
Specifications
| Running watts | 7600 W |
|---|---|
| Peak / surge | 9500 W |
| Fuel | dual-fuel |
| Run time at 50 % load | 9.5 h |
| CO shutoff | Yes |
| AC output voltage | 120 volts or 120/240 volts |
From the Pulsar page. Values the manufacturer does not publish are left out.
What is in the box
- Battery (included with the electric start)
Similar inverter & portable generators
Champion 11500-Watt Tri Fuel
9200 W, tri-fuel
WEN DF875iX
7000 W, dual-fuel
Briggs & Stratton 7000 Watt Elite Series
7000 W, gasoline
Briggs & Stratton 5750 Watt Portable Generator
5750 W, gasoline
DuroMax XP9500iH
7600 W, dual-fuel
DuroMax XP9500iHT
7600 W, tri-fuel
GenMax GM9000iED
7600 W, dual-fuel
Pulsar PGD95BISCO comparisons
- PGD95BISCO vs Westinghouse WGen9500DFc
- PGD95BISCO vs Champion 11500-Watt Tri Fuel
- PGD95BISCO vs WEN DF875iX
- PGD95BISCO vs Briggs & Stratton 7000 Watt Elite Series
- PGD95BISCO vs Briggs & Stratton 5750 Watt Portable Generator
Connection and wiring
Follow the diagrams in the Pulsar manual. Connecting to a home panel needs a transfer switch or interlock and a licensed electrician.
Error codes and troubleshooting
| Code | Meaning | What to do | Manual page |
|---|---|---|---|
| RED | Carbon monoxide has accumulated around the generator and the unit shut off due to a CO hazard. The red light flashes for at least five minutes after shut-off. Automatic shutoff with a flashing red light means the generator was improperly located. | Move the generator to an open outdoor area far from occupied spaces, with the exhaust pointed away. Once it is in a safe area, it can be restarted. Introduce fresh air and ventilate the area where the generator shut down. | 4 |
| YELLOW | A CO Sentry system fault occurred. The generator shut down automatically, and the yellow light flashes for at least five minutes after the fault. | The generator can be restarted, but it may continue to shut off. | 4 |
| CO | Detects the presence of carbon monoxide and may shut down the unit automatically for safety. | The manual gives no specific reset step for this indicator. If dizziness, weakness, or nausea occur, turn the unit off, move to fresh air, and seek medical attention. Operate only outdoors, away from enclosed spaces. | 5 |
| Low Oil LED | The engine oil level has fallen below the safe operating limit (270 ml or less). The engine shuts off automatically and cannot restart until the proper oil amount is added. | Add the appropriate oil until the level is at the proper mark. SAE 10W-30 is recommended for general use. Do not run the engine with too little oil. | 14 |
| OVERLOAD | The total load on the outlets exceeds the generator's running power. If the light turns on and the generator stops producing power, it has been overloaded. The light may flash briefly when a large device starts. | Turn off and disconnect all electrical devices and stop the engine. Compare device requirements to the generator rating and reduce connected wattage if necessary. Check and reset any tripped circuit breakers, then restart and reconnect devices without overloading. | 14 |
| LOW OIL | The engine oil level is too low. The engine shuts off automatically when the oil falls below a critical level. | Add the appropriate oil, SAE 10w-30 recommended for general use, until the oil is at the proper level. The engine cannot be restarted until the proper amount of oil has been added. | 15 |
6 of 8 codes. From the Pulsar manual. All 8 PG12000BCO / PG7750BCO / PG6580BCO / PG105TiSRCO codes →
FAQ
How long does the Pulsar PGD95BISCO run on a tank?
The maker rates it at 9.5 hours at 50 % load (about 3,800 W). A light load such as a refrigerator and lights runs longer; a full load runs shorter.
Can the Pulsar PGD95BISCO start a sump pump or well pump?
Starting surge matters more than running watts: this unit is rated 9500 W peak. That covers a typical 1/2 HP sump pump (about 2150 W to start). Use the calculator with your exact pump.