Pulsar PG7600BiSRCO error codes
3 codes from the official Pulsar manual (7600-Watt Inverter Generator (Model PG7600BiSRCO)), each with the manual page. For 1 of them the manual says to contact an authorized service dealer.
Applies to: Pulsar PG7600BiSRCO.
| Code | What it means | What to do | Service | Manual |
|---|---|---|---|---|
| CO Sentry Indicator Lights | The CO Sentry monitors accumulation of carbon monoxide gas. If increasing CO levels are detected, it automatically shuts down the engine. | The manual gives no specific reset procedure for a CO Sentry shutdown. If you experience dizziness, weakness, or nausea, immediately turn off the product, move to fresh air, and seek medical attention. | owner | p. 6 |
| Low Oil Level Light Low Oil Level Light (LOW OIL) | When the engine oil level in the crankcase falls below the safe operating limit, the red LOW OIL light turns on and the engine automatically shuts down. | Add the proper amount of engine oil. The engine cannot be restarted until sufficient oil has been added. Do not run the engine with too little oil. | owner | p. 13 |
| Overload Light Overload Light (OVERLOAD) | When the red OVERLOAD light is on, the generator is overloaded and stops output. It may light briefly when starting a large device, which is normal for loads near capacity. | Turn off and disconnect devices, then stop the engine. Reduce wattage if needed and reset any tripped circuit breakers. Restart, reconnect devices, and avoid overloading. If it happens repeatedly, have the generator serviced by an authorized Pulsar service center. | dealer | p. 13 |
Source: official Pulsar manual, read 2026-11-01. "Owner" means the manual lists steps you can take; "dealer" means it directs you to authorized service. Fuel, gas and electrical work on generators is for qualified technicians; follow the manual's safety section.