Pulsar PG7600BiSRCO Overload Light
What it means: When the red OVERLOAD light is on, the generator is overloaded and stops output. It may light briefly when starting a large device, which is normal for loads near capacity.
What to do
Turn off and disconnect devices, then stop the engine. Reduce wattage if needed and reset any tripped circuit breakers. Restart, reconnect devices, and avoid overloading. If it happens repeatedly, have the generator serviced by an authorized Pulsar service center.
When to call service
The manual directs you to an authorized Pulsar service dealer for this code if the steps above do not clear it. The unit stops or will not start until the cause is cleared.
Source: official Pulsar manual, page 13, read . Summary of the manual, not a reproduction.
Models this manual covers
Other PG7600BiSRCO codes
Questions
What does Pulsar Overload Light mean?
When the red OVERLOAD light is on, the generator is overloaded and stops output. It may light briefly when starting a large device, which is normal for loads near capacity. (Pulsar manual for the PG7600BiSRCO, page 13.)
How do I fix Pulsar Overload Light?
Turn off and disconnect devices, then stop the engine. Reduce wattage if needed and reset any tripped circuit breakers. Restart, reconnect devices, and avoid overloading. If it happens repeatedly, have the generator serviced by an authorized Pulsar service center. The manual says to contact an authorized service dealer if it continues.
Fuel, gas and electrical work on a portable / inverter generator is for qualified technicians; follow the safety section of the manual. All 3 PG7600BiSRCO codes →