Honda EU7000iS
5500 W, gas
Pulsar PG7600BiSRCO
Generator. Specs from the manufacturer page (checked ).
The Pulsar PG7600BiSRCO is a dual-fuel inverter generator rated at 6,300 running watts and 7,600 peak watts on gasoline. On propane it provides 5,700 running watts and 6,900 peak watts. It has a 3.96-gallon fuel tank, runs up to 7 hours at half load, and is rated at 62 decibels at half load.
Check on Amazon →Sponsored link; we may earn a commission.
Running
6300W
Peak / surge
7600W
Fuel
dual-fuel
Run time @50 %
7h
Noise
62dB
CO shutoff
Yes
Key features
- Runs on gasoline or propane; gasoline gives 7,600 peak and 6,300 running watts, propane gives 6,900 peak and 5,700 running watts
- Inverter technology produces a stable sine wave described as safe for sensitive electronics
- Starting methods: electric push-button, remote key fob, and manual recoil
- Outlets: two 120V 20A, one 120V 30A twist-lock, one 120/240V 50A, plus USB-A and USB-C ports
- Operates at 62 decibels at half load
- Up to 7 hours of runtime at half load on a 3.96-gallon fuel tank
- Parallel capable with a second compatible inverter generator (parallel kit sold separately) to double output
- Automatic voltage regulation, low oil shutdown, overload protection, and short circuit protection
- LCD display shows voltage, frequency, and runtime
What it is for
- Emergency backup power
- RV travel
- Mobile worksites
- Outdoor events
Specifications
| Running watts | 6300 W |
|---|---|
| Peak / surge | 7600 W |
| Fuel | dual-fuel |
| Tank | 14.99 L (4.0 gal) |
| Run time at 50 % load | 7 h |
| Noise | 62 dB |
| CO shutoff | Yes |
| AC output voltage | 120/240V |
From the Pulsar page. Values the manufacturer does not publish are left out.
What is in the box
- Propane hose
- Remote control
- Engine oil
- Oil funnel
- Spark plug wrench
- Screwdriver
- Battery charger
- User manual
Similar inverter & portable generators
Champion 5500-Watt Dual Fuel
5500 W, dual-fuel
WEN DF1100T
8300 W, dual-fuel
Champion 9000-Watt Tri Fuel Inverter (201176)
7250 W, tri-fuel
DuroMax XP9500iH
7600 W, dual-fuel
A-iPower GXS7600iRD
6100 W, dual-fuel
A-iPower SUA7600iED
6100 W, dual-fuel
WEN DF8000X
6500 W, dual-fuel
Pulsar PG7600BiSRCO comparisons
- PG7600BiSRCO vs Honda EU7000iS
- PG7600BiSRCO vs Champion 5500-Watt Dual Fuel
- PG7600BiSRCO vs WEN DF1100T
- PG7600BiSRCO vs Champion 9000-Watt Tri Fuel Inverter (201176)
- PG7600BiSRCO vs DuroMax XP9500iH
Connection and wiring
Follow the diagrams in the Pulsar manual. Connecting to a home panel needs a transfer switch or interlock and a licensed electrician.
- Electrical schematic, manual page 2 →
- Parallel connection, manual page 13 →
- Electrical schematic, manual page 21 →
Error codes and troubleshooting
| Code | Meaning | What to do | Manual page |
|---|---|---|---|
| CO Sentry Indicator Lights | The CO Sentry monitors accumulation of carbon monoxide gas. If increasing CO levels are detected, it automatically shuts down the engine. | The manual gives no specific reset procedure for a CO Sentry shutdown. If you experience dizziness, weakness, or nausea, immediately turn off the product, move to fresh air, and seek medical attention. | 6 |
| Low Oil Level Light | When the engine oil level in the crankcase falls below the safe operating limit, the red LOW OIL light turns on and the engine automatically shuts down. | Add the proper amount of engine oil. The engine cannot be restarted until sufficient oil has been added. Do not run the engine with too little oil. | 13 |
| Overload Light | When the red OVERLOAD light is on, the generator is overloaded and stops output. It may light briefly when starting a large device, which is normal for loads near capacity. | Turn off and disconnect devices, then stop the engine. Reduce wattage if needed and reset any tripped circuit breakers. Restart, reconnect devices, and avoid overloading. If it happens repeatedly, have the generator serviced by an authorized Pulsar service center. Call service if it persists. | 13 |
From the Pulsar manual. All 3 PG7600BiSRCO codes →
FAQ
How long does the Pulsar PG7600BiSRCO run on a tank?
The maker rates it at 7 hours at 50 % load (about 3,150 W) on a 4.0-gal tank. A light load such as a refrigerator and lights runs longer; a full load runs shorter.
Can the Pulsar PG7600BiSRCO start a sump pump or well pump?
Starting surge matters more than running watts: this unit is rated 7600 W peak. That covers a typical 1/2 HP sump pump (about 2150 W to start). Use the calculator with your exact pump.