Blackout Sizer Calculator
EN
Home›Portable Power Stations›A-iPower›PPS300L

A-iPower PPS300L

Power station · PPS. Specs from the manufacturer page (checked ).

A-iPower PPS300L
Photo: A-iPower

The A-iPower PPS300L is a 300Wh portable lithium power station with 250W rated output and 300W maximum output. It provides 120V/60Hz AC output using pure sine wave inverter technology.

View at A-iPower →Sponsored link; we may earn a commission.
Capacity
300Wh
Continuous
250W
Peak / surge
300W
Chemistry
LiFePO4
Cycles
300
Weight
3.58kg
Warranty
2yr

Key features

What it is for

Specifications

Capacity300 Wh
Continuous output250 W
Peak / surge300 W
Battery chemistryLiFePO4
Cycle life300 cycles
Run time at 50 % load2 h
AC output voltage120V
Weight3.58 kg (7.9 lb)
Dimensions27.9 × 12.7 × 20.3 cm (11.0 × 5.0 × 8.0 in)
Warranty2 years

From the A-iPower page. Values the manufacturer does not publish are left out.

How long it runs common appliances

ApplianceWattsRuns?Hours
Refrigerator (with freezer)120 W (600 start)surge too high—
Chest freezer100 W (500 start)surge too high—
CPAP (no humidifier)35 W (40 start)yes6.8 h
Gas boiler (pump + controls)120 W (300 start)yes4.0 h
Wi-Fi router + modem/ONU12 Wyes20 h
Starlink (standard dish)60 W (100 start)yes4.0 h
TV 50"75 Wyes3.2 h
Sump pump 1/2 HP920 W (2150 start)surge too high—
Well pump 1/2 HP880 W (2000 start)surge too high—
Space heater 1500 W1500 Wsurge too high—

Assumes 88 % inverter efficiency, 90 % usable capacity and typical duty cycles. Build your own list in the calculator.

Similar portable power stations

All A-iPower models →

Connection and wiring

Follow the diagrams in the A-iPower manual.

Open the A-iPower manual (PDF) →

Error codes and troubleshooting

We found no error-code table in this manual. Its troubleshooting section is the reference.

FAQ

How long will the A-iPower PPS300L run a refrigerator?

About 6 hours for a typical 120 W refrigerator that runs 35 % of the time, after inverter and depth-of-discharge losses.

Can the A-iPower PPS300L start a sump pump or well pump?

Starting surge matters more than running watts: this unit is rated 300 W peak. That is below a typical 1/2 HP sump pump start (about 2150 W); check your pump label. Use the calculator with your exact pump.

A-iPower PPS300LView at A-iPower