Pulsar 2200W Dual Fuel Inverter / PG1500iS / G2319N error codes
4 codes from the official Pulsar manual (PG1500iS), each with the manual page. For 1 of them the manual says to contact an authorized service dealer.
Applies to: Pulsar 2200W Dual Fuel Inverter, Pulsar PG1500iS, Pulsar G2319N.
| Code | What it means | What to do | Service | Manual |
|---|---|---|---|---|
| Engine Overload Indicator Light | The connected devices have exceeded the generator's wattage or amperage capacity, or a power surge occurred. The green AC Pilot light goes off, and power to connected devices stops while the engine keeps running. | Disconnect all electronic devices and stop the engine. Reduce the total connected wattage to within the rated output. Inspect the air inlet and control panel for blockage and clear any found, then restart the engine. | owner | p. 8 |
| OUTPUT OVERLOAD Engine Overload Indicator Light | The inverter has been overloaded beyond its wattage or amperage capacity, or by a power surge. The green AC pilot light goes off, the engine keeps running, and power to the connected loads stops. The light may flash briefly on starting a load due to surge and is normal. | Reduce the load and press the RESET button. If resetting does not solve the problem, disconnect the load and shut down the engine. Inspect the air inlet and air outlet for blockage and remove any found. | owner | p. 8 |
| Oil Warning Indicator Light | Oil has fallen below the minimum level. The light comes on and the engine stops automatically. | Add the correct volume of engine oil (SAE 10W-30) to the crankcase. The engine will not start until the correct oil volume is in the crankcase. | owner | p. 8 |
| DC Circuit Breaker DC Circuit Breaker Trip | The DC circuit breaker turns OFF automatically when connected loads exceed the generator's rated output, and the generator stops supplying power. | Reduce the connected loads to within rated DC output, then return the DC Circuit Breaker to the ON position to restore power. If the breaker turns off again, stop using the generator immediately and consult a local, authorized Pulsar dealer. | dealer | p. 9 |
Source: official Pulsar manual, read 2026-11-03. "Owner" means the manual lists steps you can take; "dealer" means it directs you to authorized service. Fuel, gas and electrical work on generators is for qualified technicians; follow the manual's safety section.