Pulsar 2200W Dual Fuel Inverter OUTPUT OVERLOAD
What it means: The inverter has been overloaded beyond its wattage or amperage capacity, or by a power surge. The green AC pilot light goes off, the engine keeps running, and power to the connected loads stops. The light may flash briefly on starting a load due to surge and is normal.
What to do
Reduce the load and press the RESET button. If resetting does not solve the problem, disconnect the load and shut down the engine. Inspect the air inlet and air outlet for blockage and remove any found.
When to call service
The manual lists steps the owner can take. If the code comes back after them, or you are unsure, contact an authorized service dealer. A warning: the unit may keep running, but the cause needs attention.
Source: official Pulsar manual, page 8, read . Summary of the manual, not a reproduction.
Models this manual covers
Pulsar 2200W Dual Fuel Inverter, Pulsar PG1500iS, Pulsar G2319N.
Other 2200W Dual Fuel Inverter codes
Questions
What does Pulsar OUTPUT OVERLOAD mean?
The inverter has been overloaded beyond its wattage or amperage capacity, or by a power surge. The green AC pilot light goes off, the engine keeps running, and power to the connected loads stops. The light may flash briefly on starting a load due to surge and is normal. (Pulsar manual for the 2200W Dual Fuel Inverter, page 8.)
How do I fix Pulsar OUTPUT OVERLOAD?
Reduce the load and press the RESET button. If resetting does not solve the problem, disconnect the load and shut down the engine. Inspect the air inlet and air outlet for blockage and remove any found.
Fuel, gas and electrical work on a portable / inverter generator is for qualified technicians; follow the safety section of the manual. All 4 2200W Dual Fuel Inverter codes →