Vtoman FlashSpeed 1000
828 Wh, 1000 W
Bluetti AC70P
Power station. Specs from the manufacturer page (checked ).
The BLUETTI AC70P is an 864 Wh portable power station with 1,000 W rated continuous output. It uses LiFePO₄ batteries rated for over 3,000 charge cycles while retaining 80% capacity. Its Power Lifting Mode raises output to 2,000 W for resistive loads.
Check on Amazon →Sponsored link; we may earn a commission.
Capacity
864Wh
Continuous
1000W
Chemistry
LiFePO4
Cycles
3000
Expandable
Yes
Key features
- 1,000 W rated continuous output; Power Lifting Mode boosts output up to 2,000 W for resistive loads such as electric grills, hairdryers and kettles
- Wall charging at up to 950 W AC input, with Silent, Standard and Turbo Charging modes
- Turbo Charging can fill the unit in 1.5 hours from a wall outlet when enabled in the BLUETTI App
- Silent charging mode produces 45 dB of sound
- Can charge and discharge at the same time
- Bluetooth control through the BLUETTI App
- Can be expanded with B230 or B300 batteries in Power Bank Mode
- Charges from wall, solar (12V-58V open circuit input, MC4 connectors), car, generator or LiFePO₄ battery; not waterproof
What it is for
- Outdoor adventures
- RV trips
- Home use
Specifications
| Capacity | 864 Wh |
|---|---|
| Continuous output | 1000 W |
| Expandable | Yes |
| Battery chemistry | LiFePO4 |
| Cycle life | 3000 cycles |
| AC charging | fill it up in only 1.5 hours |
From the Bluetti page. Values the manufacturer does not publish are left out.
How long it runs common appliances
| Appliance | Watts | Runs? | Hours |
|---|---|---|---|
| Refrigerator (with freezer) | 120 W (600 start) | yes | 16 h |
| Chest freezer | 100 W (500 start) | yes | 23 h |
| CPAP (no humidifier) | 35 W (40 start) | yes | 20 h |
| Gas boiler (pump + controls) | 120 W (300 start) | yes | 11 h |
| Wi-Fi router + modem/ONU | 12 W | yes | 57 h |
| Starlink (standard dish) | 60 W (100 start) | yes | 11 h |
| TV 50" | 75 W | yes | 9.1 h |
| Sump pump 1/2 HP | 920 W (2150 start) | surge too high | — |
| Well pump 1/2 HP | 880 W (2000 start) | surge too high | — |
| Space heater 1500 W | 1500 W | surge too high | — |
Assumes 88 % inverter efficiency, 90 % usable capacity and typical duty cycles. Build your own list in the calculator.
Similar portable power stations
Vtoman Jump 1500X
828 Wh, 1500 W
Anker SOLIX C800 Plus
768 Wh, 1200 W
Dabbsson 600L
768 Wh, 600 W
EcoFlow RIVER 2 Pro
768 Wh, 800 W
Pecron F1000LFP
960 Wh, 1500 W
Dabbsson 1000L
1008 Wh, 1200 W
DJI Power 1000 Mini
1008 Wh, 1000 W
Connection and wiring
Follow the diagrams in the Bluetti manual.
Open the Bluetti manual (PDF) →
Error codes and troubleshooting
| Code | Meaning | What to do | Manual page |
|---|---|---|---|
| E004 | The output voltage is outside the expected range, or the grid connection is not proper. | Ensure the output voltage is within ±10% of the rated voltage or proper grid connection. | 21 |
| E016 | The internal fan is blocked, unplugged, or not functioning properly. | Check if the fan is blocked, unplugged, or not functioning properly. Ensure proper ventilation. | 21 |
| E117 | Grid oscillation has been detected at the grid input. | Disconnect the grid input and contact BLUETTI support for further assistance. Call service if it persists. | 21 |
| E074 | The battery management system (BMS) has detected a fault. The specific fault is shown in the mobile app. | Check the specific fault in the mobile app. If the battery is too hot or too cold, let the unit reach a suitable temperature before charging or using it (charging -15°C to 40°C; discharging -25°C to 40°C). | 22 |
| E001 | The inverter is overloaded because the connected devices draw too much power. | Check whether the power consumption of your devices is too high. Reduce the load if necessary. | 23 |
| E002 | The inverter overheated and protection switched the AC output off. | Wait for about 10 minutes until the unit cools down, then turn on the AC output again. | 23 |
6 of 22 codes. From the Bluetti manual. All 22 Elite 200 V2 / Apex 300 / Elite 100 V2 / AC70 codes →
FAQ
How long will the Bluetti AC70P run a refrigerator?
About 16 hours for a typical 120 W refrigerator that runs 35 % of the time, after inverter and depth-of-discharge losses.
Can the Bluetti AC70P start a sump pump or well pump?
Starting surge matters more than running watts: this unit is rated 1000 W output (no separate peak published). That is below a typical 1/2 HP sump pump start (about 2150 W); check your pump label. Use the calculator with your exact pump.